Power optimization · EnePro
Clean up the power your equipment runs on.
EnePro is a power optimizer installed at your electrical panel or right at your equipment. It cleans up harmonic distortion, corrects power factor and absorbs surges, so your motors and compressors waste less energy as heat, run cooler and last longer.
The problem
Power quality, in plain English.
Power leaves the generating plant clean. By the time it reaches your building, it has travelled miles of lines shared with other customers, and it can arrive already distorted. Then the equipment inside your building adds more distortion of its own. EnePro cleans up both.
Poor power factor
Motors draw extra current that does no useful work. The wiring still has to carry it, and some utilities add a charge for it.
Harmonics
Distortion comes in two ways: some arrives on the utility line, and drives, compressors and electronics inside your building create more. Distortion turns into heat in your wires, motors and transformers, which wastes energy and shortens equipment life.
Voltage surges
Short spikes from switching loads or the grid. Each one adds wear to sensitive controls and motor windings.
What EnePro does
Three jobs, one device.
Power factor correction
Supplies the reactive power your motors need locally, so less unused current travels through your system.
Harmonic elimination
Cleans up distortion coming in from the utility and distortion created by your own drives and compressors, bringing the wave back toward clean.
Surge protection
Absorbs short voltage spikes before they reach your equipment.
The payoff
What it means for your bill and your equipment.
Less wasted energy
Cleaner power means less energy lost as heat in your wiring and motors.
Longer equipment life
Motors and compressors that run cooler last longer and fail less often.
Fewer surprises
Surge protection and cleaner power reduce nuisance trips and damage to controls.
Built for payback
You get your investment back in a few months, then the savings keep coming for years. Your proposal shows the numbers for your site.
Where it fits
Built for motor-heavy loads.
If your facility runs a lot of motors for long hours, it is worth a look.
Every install is done by a qualified electrical contractor.
- HVAC systems and rooftop units
- Pumps and lift stations
- Air compressors
- Refrigeration and cold storage
- Production lines and process equipment
At the service panel 
At the equipment
Free bill review
Send us one bill. We will tell you what the numbers support.
One recent electric bill is enough to start. Add a water bill if you have one.
What happens next
- 01
Send a recent bill
Upload a PDF or a photo, or call and we will walk you through it.
- 02
We review it with our engineering partners
Your rate, demand charges and usage pattern, line by line.
- 03
You get a straight answer
What fits your site, and what does not. No pressure either way.
- No cost
- No obligation
- Across North America