Commercial energy and water efficiency
Cleaner power.Smarter water.Stored energy.
Enzo NRG lowers the cost of running a commercial facility. We start with a free review of your bills and only recommend what the numbers support.
- Free bill review
- No obligation
- Licensed crews
The problem
Most commercial buildings overpay in three places.
None of them shows up as its own line item you can act on. That is why they last for years.
Poor power quality
Power can reach your building already carrying distortion from the grid, and the motors, compressors and drives inside add more. You pay for energy that turns into heat instead of work, and your equipment wears out sooner.
Paying for air in your water
Your water meter measures volume, and it counts air in the line as water. Sewer is usually billed on that same reading, so you can end up paying for that air twice, every month.
Peak demand charges
Many utilities bill your single highest stretch of use each month. One busy afternoon can set the price for the whole month. A battery can trim that peak, and in select markets you can get paid thousands of dollars a year to host one.
What we install
Four ways to cut what it costs to run your facility.
Every one of these is about payback: you get your investment back in a few months, then the savings keep coming for years. Each one starts with your bill. If the numbers do not support it, we will say so.
- EnePro
Power optimization
Cleaner power for motor-heavy equipment. Less energy lost as heat, longer equipment life, and protection from surges.
- Poor power factor
- Harmonics
- Voltage surges
- AquaFlow
Water efficiency
One valve after your water meter so you pay for water, not air, on both your water and sewer bill.
- Turbulent flow
- Air in the line
- Volume-based billing
Battery storage
Get paid to host a battery in select markets, or use storage for backup power and lower peak charges.
- Hosting payments
- Backup power
- Peak demand charges
- Coat Zone
HVAC coatings
Protective coatings that help rooftop HVAC run cooler, use less power and last longer.
- Coil corrosion
- Solar heat gain
- Rooftop wear
We also handle commercial solar and EV charging.
For facilities ready for long-term generation or charging for staff, customers and fleets.
Watch
See how it works in 60 seconds.
One minute on each product. Then send us your bill and we will run the numbers for your site.
EnePro: cleaner power
To learn more, watch the full video.AquaFlow: stop paying for air
To learn more, watch the full video.
Our rule
We only recommend what the numbers support.
If your bill shows little room to save, we will tell you that. No pitch before we have read your numbers.
How it works
From your bill to a working install, in five steps.
- 01
Send us a recent bill
Upload an electric bill, plus a water bill if you have one. A photo or PDF is fine.
- 02
We review it with our engineering partners
We read your rate, demand charges and usage pattern to see where your facility is losing money.
- 03
Site survey
We visit to look at your electrical service, equipment, waterline and roof, whatever applies.
- 04
A proposal with the numbers for your site
You get a written proposal for your facility. If the numbers do not support a product, it is not in the proposal.
- 05
Installation by licensed crews
Licensed electricians, plumbers and installers do the work, coordinated by us.
Industries
Built for facilities that run hard.
Free bill review
Send us one bill. We will tell you what the numbers support.
One recent electric bill is enough to start. Add a water bill if you have one.
What happens next
- 01
Send a recent bill
Upload a PDF or a photo, or call and we will walk you through it.
- 02
We review it with our engineering partners
Your rate, demand charges and usage pattern, line by line.
- 03
You get a straight answer
What fits your site, and what does not. No pressure either way.
- No cost
- No obligation
- Across North America